Mercedes-Benz E-Class Sedan Operator's Manual page 148

146 Driving and parking
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly, until the door closes.
When the door closes, programming is com‐
pleted.
% Please also read the operating instructions
for the garage door drive.
Troubleshooting when programming the
remote control
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control
#
a distance between 1 in (1 cm) to 3 in (8 cm)
2
in front of the inside rearview mirror. You
should test every position for at least 25 sec‐
onds before trying another position.
#
#
#
%
5 at various angles at Opening/closing the garage door
Prerequisite
The corresponding button is programmed to
operate the garage door.
Hold remote control 5 at the same angles
at various distances in front of the inside
rearview mirror. You should test every posi‐
tion for at least 25 seconds before trying
another position.
Note that some remote controls transmit
only for a limited period, press button
remote control 5 again before transmission
ends.
Align the antenna line of the garage door
opener unit with the remote control.
Support and additional information on pro‐
gramming:
®
On the toll free HomeLink
R
1-800-355-3515.
On the Internet at http://
R
www.homelink.com/mercedes.
6 on
Hotline on