Layout - Leica Rugby 840 User Manual

5.4.7
Description

Layout

Setup
Rugby 840, Applications
Layout
In the laying down position the Rugby 840 can be used for laying out wall positions,
squaring, transferring points and more.
The Rugby 840 projects two laser beams at a 90° angle to each other.
004813_001
Step Description
1. Place the Rugby in the laydown position.
2. Press the power button to turn on the Rugby.
The Rugby will always turn on in Automatic Mode. Allow the Rugby to self-
level.
3. In the laying down position the Rugby will move the beam to downwards for
alignment over your reference.
4. Start the head rotation or scanning motion to roughly align the beam to a
second control point.
5. Using the buttons on the laser or the remote control, fine adjust the beam
until striking the second control point.
6. Once aligned the split beam and rotating beams can be used to locate 90°
angles for layout. The rotating beam also creates a vertical plane for trans-
ferring points from the floor to the ceiling.
When using the Rugby in the laydown position use the
left or right arrow buttons on your remote control to
quickly align the vertical plane or plumb beam to the
second reference point. (1).
The scanning beam can be moved quickly to the left or
right side of the laser using the Scan 90° button (2).
To check the alignment over a point press the Beam
down button (3).
5
4
2
1
3
1
2
004814_001
1
3
38