Pairing The Rugby 840 With The Rc400 Remote Control - Leica Rugby 840 User Manual

Applications
2.5.1
Pairing step-by-step

Rugby 840, Description of the System
• For layout work use the Beam down feature to position the beam over a reference
point. Then use the Scan 90° feature to quickly move the small scan to a position
to the left or right of the laser.
• For ceiling applications and marking elevations the Scan 90° feature can quickly
bring the scanning beam to you.

Pairing the Rugby 840 with the RC400 Remote Control

The Rugby 840 and the RC400 Remote Control include radio devices that allow the
user to activate additional functions on the Rugby.
When purchased together, the Rugby 840 and the RC400 have been paired together
at the factory. Should it be necessary to pair your units after purchase, the following
information is applicable.
Before using the RF features, the Rugby and the Remote Control must first be paired
together to be able to communicate with each other.
Step Description
1. Turn off the Rugby 840.
2. Press and hold the Power button on the Rugby 840 for 5 seconds to turn on
the Rugby 840 in pairing mode. The Rugby 840 beeps five times.
3. Press and hold the Head Speed button and the Scan Mode button on the
RC400.

The X-axis Indicator LED and the Y-axis Indicator LED flash green and the
Rugby 840 beeps five times quickly when the pairing was successful.
The X-axis Indicator LED and the Y-axis Indicator LED flash red five times
quickly if the pairing was not successful.
Refer to "4.3 Pairing the Rod Eye 180 with the Rugby 840" for information on pairing
the Rugby with the receiver.
18