Diagnostics; Programmable Options - CrimeStopper CS-2015.FM.RevB Installation Instructions Manual

11. 10/60 Sec. OPEN DOOR WARNING
This setting changes the delay time in which the alarm system begins to monitor the Door circuit. This option can
prevent the alarm from giving warning chirps on vehicles with a delayed dome light.
12. DOOR LOCK/UNLOCK PULSE TIME
This option controls the amount of time (0.75 sec. or 3 sec.) for the lock/unlock pulse. The standard pulse time for
most vehicles is 0.75 Sec. The 3 sec. setting may be required for Mid 1980's through Mid 1990's European Vehicles
that require a long lock and unlock pulse to operate Vacuum door lock systems.
13. DOUBLE UNLOCK PULSE
With this option ON, the unit will send 2 unlock pulses when the system is disarmed. This feature may be required for
interfacing a Factory alarm or keyless entry system.
14. REMOTE START ENGINE RUN TIME
Set engine run time for remote start for 12, 24, 36 or 48 minutes as desired.
15. OPTION RESET – RESTORE ALL OPTIONS TO DEFAULT VALUES
Pressing button #2 at this option level will restore all option values/settings to (* = Default values).
The CS-2011RS and CS-2015FM systems include disarm diagnostics, through the LED light, that will help in
determining what caused the last trigger of the alarm system. This is a valuable tool in determining how the vehicle
was tampered with or if there is a false alarm problem in which case you can make the necessary adjustments to
correct the problem.
When the system is disarmed with the remote you will hear the normal 2 chirps, then 4 quick chirps that indicate the
alarm was triggered while you were away. Check the LED light for a sequence of flashes:
Shock Sensor Violation = 1 Flash
Hood/Trunk = 3 Flashes
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.

PROGRAMMABLE OPTIONS

LED DIAGNOSTICS
Door Violation = 2 Flashes
Ignition Violation = 4 Flashes