CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 5

Orange: (-) Negative Starter Disable / Anti-Grind Output
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
Orange/Black: (-) OEM Disarm Output
This wire provides a Ground pulse to disarm vehicles' Factory anti-theft system prior to a Remote Start. Connect this
wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at
the Factory Anti-theft control module.
PIN 1: BROWN: STARTER OUTPUT (30A)
PIN 2: GRAY: ACCESSORY or IGNITION 2 (30A)
PIN 3: RED: BATTERY CONSTANT FUSED (30A)
PIN 4: RED: BATTERY CONSTANT FUSED (30A)
PIN 5: PINK: IGNITION 1 (30A)
PIN 6: WHITE (18 Ga.): (+) PARKING LIGHTS (10A)
NOTE!: Use External Relays for High Current Ignition and/or Accessory
circuits greater than 30A. Failure to do so could result in damage to the
unit that is not covered under warranty.
WIRING: 9-PIN Harness
IGN. SWITCHED
STARTER WIRE
YELLOW
BLUE
ORANGE
BROWN
WIRING: 6-PIN High Current Connector
CUT
ORANGE
CAUTION!: CHECK ALIGNMENT
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!
OF PLUG TO PINS. IF THE
HARNESS IS UPSIDE
DOWN, STARTER OUTPUT
WILL BE CONNECTED TO
PARKING LIGHTS!