CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 7

Red/White: Tachometer Input
When installing this system in TACH REFERENCE mode, this wire must be connected to a valid source of AC voltage.
This wire allows the unit to sense the engine running. See Tach Reference Section on Pg. 13 for more information.
Black: Chassis Ground
Connect to body metal of the vehicle using a sheet metal screw and a star washer to ensure a good ground. Keep the
Ground wire short. Scrape away and paint or debris from ground location.
Yellow/White: (-) Accessory Output (For Adding Accessory or IGN2 Relays)
Yellow: (-) Ignition 1 Output (For Adding Ignition Relays OR Anti-Theft Bypass Module)
Use these wires when the vehicle requires a second IGNITION 1, IGNITION 2, or ACCESSORY wire to be activated.
This occurs commonly in Toyota, and late model GM cars. Use these wires for activation of Anti-Theft Modules for GM
or Transponders. Use a CS-GMATA for GM Vehicles, CS-TATA for Transponder Keys. See diagram below.
YELLOW
OR
(YELLOW/WHITE)
(2nd IGN2 /ACC WITH YEL/WHT)
Violet: (+) Door Pin Switch Input
Same as the GREEN wire below except this wire is used for vehicles that show a positive voltage (12 volts) when the
door is open and a ground when doors are closed as in many Ford, Lincoln, and Mercury vehicles.
Green: (-) Door Pin Switch Input
Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles may
have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to the
wire that triggers the vehicle's interior dome light. Sometimes newer vehicles contain a separate body control module
(BCM) where the door trigger circuit can be located. Most vehicles will NOT require the use of BOTH Green and Violet
door trigger wires.
WIRING: 4-PIN Harness
OR
85
30
2nd IGN 1
OR
WIRING: 5-PIN Harness
ANTI-THEFT
MODULE
86
+
87
BATTERY
-
IGN SW.