CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 8

Blue: (-) Hood/Trunk Pin Switch Input
Input trigger for a grounding hood or trunk pin switch. Connect to existing hood and trunk pin switches that read
ground when open. If no existing switches are available, install new pin switches if desired. Note: DO NOT mount
new pin switches in water pathways. The kit includes a pre-terminated 6" brown wire end for connecting to the
supplied hood pin switch terminal.
Pink: (+12V) Diesel Glow Plug Input or Car Jack Input (Programmable Input Wire)
Glow Plug (Diesel):
Connect to the indicator circuit that shows +12 volts while the "WAIT TO START LAMP" is on. When this wire is
used, the system will wait until the light turns off before attempting a remote start. Note: An inverter module or
relay can be used for vehicles that have a Negative wait to start lamp circuit.
Carjack Trigger
When using Carjack protection, connect this Pink wire to a toggle switch, or positive door trigger or ignition
depending on your level of Carjack protection. When +12V is applied to this wire, with the IGN on, then Carjack
is armed. If a door is opened then closed, a Carjack countdown will begin. See Diagram Below for wiring
configurations. DO NOT connect the Pink Carjack wire to Ignition unless there is extreme danger of a Carjack.
When using the Ignition, Carjack is armed all the time and must be reset each time a door is opened and closed.
HIDDEN BUTTON or
TOGGLE SWITCH
(Not Included)
PINK
CONTROLLED W/SWITCH
White: (+12V) Brake Reset
Connect the White wire to the side of brake pedal switch that shows +12 volts ONLY when pedal is depressed. This
will turn off the remote start if someone attempts to drive the car without the keys or if the Ignition key is not turned on
all the way.
WIRING: 5-PIN Harness
OPTIONAL CAR JACK WIRING:
12 V
+
IGN SW
+ IGN
PINK
FULL-TIME CARJACK