Designing The User System; Connecting The E1/E20/E2/E2 Lite To The User System; Installing The Connector On The User System; Connecting The User System Interface Cable To The 14-Pin Connector - Renesas E1 User Manual

E1/E20/E2/E2 Lite Additional Document

2. Designing the User System

2.1

Connecting the E1/E20/E2/E2 Lite to the User System

To connect the E1/E20/E2/E2 Lite to the user system, a connector for the user system interface cable
must be mounted on the user system.
When designing the user system, read this section of this manual and the hardware manual for the MCU
in use.
2.2

Installing the Connector on the User System

Table 2-1 shows the recommended connectors for the E1/E20/E2/E2 Lite.
Table 2-1 Recommended Connectors
Connector
14-pin
connector
Note: Connection to the 38-pin connector of the E20 is not supported. To use the E20, use the 38-pin to 14-pin
conversion adapter that comes with the E20 for connection to the 14-pin connector on the user system.
2.2.1

Connecting the User System Interface Cable to the 14-Pin Connector

The following figures show how to connect the user system interface cable to the 14-pin connector of
each emulator.
E1/E2 Lite: Figure 2-1 (Connecting the User System Interface Cable to the 14-Pin Connector of the
E1/E2 Lite Emulator)
E20: Figure 2-2 (Connecting the User System Interface Cable to the 14-Pin Connector of the E20
Emulator)
E2: Figure 2-3 (Connecting the User System Interface Cable to the 14-Pin Connector of the E2
Emulator)
Figure 2-1 Connecting the User System Interface Cable to the 14-Pin Connector of the E1/E2 Lite
Emulator
R20UT2937EJ0301 Rev.3.01
Jul 1, 2020
Type Number
7614-6002 3M Japan Limited
2514-6002 3M Limited
14-pin user-system interface cable
Pin 2
Manufacturer
14-pin straight type (Japan)
14-pin straight type (other countries)
Pin 1
2. Designing the User System
Specifications
14-pin connector
7614-6002 or
2514-6002
User system
Page 13 of 45