Crestron CLF-DIMRFB Operation Manual page 21

Crestron CLF-DIMRFB
Release Gateway Connection
In some cases, it might be desirable to release a dimmer from a gateway.
If a dimmer is to be released from a gateway, the gateway information
must be cleared from the dimmer's memory.
To clear a dimmer's gateway information:
1. Move the mode selection switch to the "OFF" position.
2. Press and hold the foot switch on the CLF-DIMRFB, while sliding
3. Hold the foot switch for approximately 10 seconds until the LED
A dimmer can also be released from a gateway using Toolbox. Refer to
the latest revision of the C2N-MNETGW guide (Doc. 6317) for
instructions.
Restore Default Settings
To restore the dimmer's default settings, press and hold the foot switch
while the unit is in the RUN mode. Then, while still holding the foot
switch, move the mode selection switch to the "SET" position and back
to the "RUN" position. Release the foot switch.
The factory default settings are:
Preset
Fade time
Ramp rate
Lower limit
LED Behavior
The CLF-DIMRFB has a single amber LED. Its behavior is determined
by the current state of the dimmer or the control system program.
For reference, the LED can be in one of three intensity levels: OFF,
LOW and HIGH.
Operations Guide – DOC. 6479
To communicate with the control system program, an MNET ID
value between 03 and 20 must be assigned to the dimmer. Refer to
"Identity Code" on page 6.
the mode selection switch to the "RUN" position.
flashes twice. Release the foot switch at this point and the gateway
connection will have been removed.
100%
0.5seconds
3 seconds
10%
infiNET
™ Lamp Dimmer: CLF-DIMRFB • 17
infiNET
™
Lamp Dimmer