Mitsubishi Electric MELSEC-Q Structured Programming Manual page 293

FXCPU Structured Programming Manual
[Device & Common]
4. On the "Built-in CC-Linc/LT Setting" dialog box, set the built-in CC-Link/LT.
The " Built-in CC-Linc/LT Setting" tab is available only in FX
Set item
Transmission Speed
Point Mode
Station No.
Station Type
I/O Points
Specify Reserved Station
Up
Down
Insert Line
Delete Line
Read Buffer Memory
*1. Select the 16-point mode when using a remote device station. Remote device stations cannot be set
in the 4-point mode.
Available station numbers are 49 to 64.
*2. I/O Points setting "32", "48" and "64" are available only when "Remote device station" is selected as
the station type.
5. Click the [OK] button to finish the setting and close the "Special Module Initial Setting"
dialog box.
Contents of setting
Select the transmission speed of the built-in CC-link/LT among the following
choices:
2.5Mbps
625kbps
156kbps
Select the point mode of the built-in CC-link/LT between the following choices:
16-point mode
4-point mode
Set the station number of the built-in CC-link/LT.
1 to 64 can be set.
Select the station type of the built-in CC-link/LT among the following choices:
Remote I/O Station [Input]
Remote I/O Station [Output]
Remote I/O Station [Input/Output]
*1
Remote device station
Select the number of points in the remote I/O station or remote device station.
Select whether the station is reserved or not in the built-in CC-link/LT.
This button moves the cursor to the upper line (transposes the upper line).
This button moves the cursor to the lower line (transposes the lower line).
This button inserts a line in the currently selected position.
This button deletes the currently selected line.
This button reads out the transmission speed, point mode and station
information of the built-in CC-link/LT.
6 Types and Setting of Parameters
6.6 Parameter setting by GX Works2
-32MT-LT-2 PLC.
3UC
Setting range
1 to 16,32,48,64
1
2
3
4
-
5
-
-
6
-
*2
-
-
7
-
-
-
-
291