Mitsubishi Electric MELSEC-Q Structured Programming Manual page 290

FXCPU Structured Programming Manual
[Device & Common]
6
Setting the PLC system (2)
The "PLC System(2)" tab is available only in FX
FX and FX
3U 3UC
1. Click the "PLC System(2)" tab.
2. Only when setting the communication for a serial port of the extended PLC, select a channel
to be set and check the check box "Operate Communication Setting".
Uncheck this check box when not setting the communication for a serial port.
Set item
Channel selection
Operate Communication
Setting
Protocol
Data Length
Parity
Stop Bit
Transmission Speed
Header
Terminator
Control Line
H/W Type
Control Mode
Sum Check
Transmission Control
Procedure
Station Number Setting
Time Out Judge Time
*1. In FX
3S
288
PLCs.
*1
Select a channel in which a serial port is set.
Check this item when using the selected serial port in "computer link", "no-protocol
communication" or "inverter communication".
Uncheck this item when transferring and monitoring sequence programs in GX
Works2 or when using the selected serial port in N : N Network, parallel link,
MODBUS communication or FX
Set each item in accordance with the application.
PLC, channel is fixed to "CH1".
, FX , FX , FX
1S 1N 1NC
Contents of setting
3U -ENET-ADP.
→ For details on each item, refer to the data communication manual.
6 Types and Setting of Parameters
6.6 Parameter setting by GX Works2
, FX , FX , FX
2N 2NC 3S 3G
Setting range
CH1, CH2
, FX ,
3GC
-