Mitsubishi Electric MELSEC-Q Structured Programming Manual page 291

FXCPU Structured Programming Manual
[Device & Common]
7
Setting special function block
The "Special Function Block" tab is available only in FX
1. Click the "Special Function Block" tab, and then set the special function block/unit name
and built-in CC/Link.
When setting special units, it is necessary to check in advance the check box "Special
Function Block Settings" on the "Memory Capacity" tab.
When setting the station information in "Built-in CC-Link/LT Setting", it is necessary to
check in advance the check box "Built-in CC-Link/LT Setting" on the "Memory Capacity"
tab.
Set item
Special Function Block
*1
Setting
Built-in CC-Link/LT
*2
Setting
*1. Check in advance the check box "Special Function Block Settings" on the "Memory Capacity" tab.
*2. Check in advance the check box "Built-in CC-Link/LT Settings" on the "Memory Capacity" tab.
This item can be set only in the FX
Unit No. This is the unit number of each special function block/unit.
Input the name of each special function block/unit whose initial values will
Unit Name
be set.
Up This button moves the cursor to the upper line (transposes the upper line).
Down This button moves the cursor to the lower line (transposes the lower line).
This button displays the "Special Module Initial Setting" dialog box for the
Setting selected unit number.
Delete This button deletes the setting of the selected unit number.
This button deletes all current setting in the "Special Function Block
Delete All
Setting" field.
Read PLC This button reads the current setting in the "Special Function Block Setting"
Data field from the connected PLC.
Setting This button displays the "Built-in CC-Link/LT Setting" dialog box.
-32MT-LT-2.
3UC
6 Types and Setting of Parameters
6.6 Parameter setting by GX Works2
, FX PLCs.
3U 3UC
Contents of setting
→ Refer to the next page.
1
2
3
4
5
6
Setting range
-
Up to 32 half-width
(or 16 full-width)
characters
-
7
-
-
-
-
-
-
289