CYCLONE PRO
Trim Programming
The "Trim Programming" checkbox enables automatic calculation and
programming of the trim value in a designated Non-Volatile memory
location.
Sync to PLL Change
"Sync to PLL Change" is required for the software/hardware connection to
synchronize with the microprocessor during the flash erasing/
programming procedure.
Start Expert Mode Programmer
"Start Expert Mode Programmer" grants the user access to P&E's
graphical flash programming utility, PROG08SZ. PROG08SZ lets an
advanced user control the step-by-step execution of the flash erase/
programming procedure. See Figure 8-23. More information on how to
use PROG08SZ can be found on P&E Microcomputer Systems website
at: www.pemicro.com.
Figure 8-23: PROG08SZ Software
80
Cyclone PRO User Manual