Freescale Semiconductor PE Micro Cyclone Pro User Manual page 20

CYCLONE PRO
The MON08 Connector adopts the standard pin-out from MON08 debugging
(as used on different ICS boards) with some modifications. The general pin-
out is as follows:
The physical locations of the pins are displayed below:
Please note that NC designates that these pins are reserved for future P&E
use. Make sure you do not connect any signal to these lines.
The MON4-MON8 signals are software configurable to support connections to
different HC08 devices. Depending upon the device, either the MON4 or
MON5 pin is the single-wire communications line (which usually corresponds
to PORTA0 or PORTB0). The rest of the lines are either No Connect or are
port lines which must be put to particular values upon reset. The Cyclone
PRO software lists the target processor types and their corresponding pin-
outs for user references. The software also selects the single-wire
communications line according to the target processor type. The specific
14
PIN 1 -
PIN 3 -
PIN 5 -
PIN 7 -
PIN 9 -
PIN11 -
PIN13 - OSC
PIN15 - Vout
Figure 3-9: 16-Pin MON08 Connector Pin Locations
NC GND - PIN 2
NC RST - PIN 4
NC IRQ - PIN 6
NC MON4 - PIN 8
NC MON5 - PIN10
NC MON6 - PIN12
MON7 - PIN14
MON8 - PIN16
Cyclone PRO User Manual