Freescale Semiconductor PE Micro Cyclone Pro User Manual page 50

CYCLONE PRO
5.1.4 Target Voltage and Power Settings
A user may elect to use Cyclone PRO to supply power to the target (and this
is a requirement for HC908 targets). In this case, the Target Voltage specifies
the target MCU I/O voltage level.
The user needs to take into account the power discharge time for the Power
Down delay. The reset driver delays, power stabilization time, and the target
clock stabilization time should be considered for the Power Up delay.
A checkbox is available for a user to instruct the Cyclone PRO to turn off
target power after SAP operations. If unchecked, the target power will remain
on.
For architectures other than HC908, options are available for the user to
provide Reset Delay if some reset monitoring devices are used, and to
determine whether to drive the BKGD signal to GND after operations are
complete to assist programming the next target.
5.1.5 Image Description
The Cyclone PRO Configuration Utility allows the user to summarize the
purpose of current configuration for future reference. The description will be
either programmed into the Cyclone PRO or saved into an encrypted file.
The image description will appear on the LCD screen for image identification.
Since the LCD can display up to 16 characters, it is recommended to keep the
description concise.
This field will not affect the Cyclone PRO's operations with the target.
5.1.6 Store Image To Cyclone
"Store Image to Cyclone" allows the current configuration to be programmed
into the Cyclone PRO. The Cyclone PRO will then be ready for operations.
44 Cyclone PRO User Manual