Freescale Semiconductor PE Micro Cyclone Pro User Manual page 80

CYCLONE PRO
Figure 8-18: Connection Manager Dialog - P&E Multilink/Cyclone PRO
This dialog can be used by the user to manually enter the proper security
bytes via the USER setting, or to load the security bytes from the same .S19
file which was programmed. The bytes are loaded from an .S19 file by clicking
the "Load from S19" button.
IGNORE Security Failure And Enter Monitor Mode
This checkbox can be used to cause the software to ignore a failure to
properly pass the 68HC08 security check. If the checkbox is set, the software
will attempt to establish monitor mode communications regardless of the
security status. As long as the Baud and Port are correct, and the device has
been properly powered, this will allow monitor mode entry. By ignoring the
security check failure you may use monitor mode, but the ROM/Flash will not
be accessible.
Note: If a connection is not established for a reason other than security failure, the
connection dialog will always appear.
8.3.5 STATUS
The status area consists of one status string following the "Status:" label, and
74 Cyclone PRO User Manual