CYCLONE PRO
Figure 3-18: Via Cyclone PRO Board Power and Pin 6 of Cyclone PRO BDM
Jumpers 2, 3, and 4 are enabled as shown in Figure 3-19.
Figure 3-19: Jumper Settings for Target Power Connection via Cyclone PRO
3.12.4
Using Power IN Jack And MON08 Header Pin 15
A center positive power supply is connected to the Power IN Jack of the
Cyclone PRO. Pin 15 of the Cyclone PRO MON08 header provides the
appropriate voltage for MON08 targets.
20
Board Power and Pin 6 of Cyclone PRO BDM Connector
Connector
.
Cyclone PRO User Manual