Model Assembly - Horizon Hobby E-flite Carbon-Z Cub SS Instruction Manual

Model Assembly

Required Adhesives:
Thread Lock
Landing Gear Installation
1. Install a tundra tire (A) on the strut (B) using 2 wheel collars (C) as shown.
Ensure the set screws (D) are aligned with the flat spots on the strut. Apply
threadlock and tighten. Repeat tire installation for the opposite strut.
2. Insert the legs of the strut assembly into the landing gear brackets (E) located
on the bottom of the fuselage.
3. Align the holes of the strut legs with the holes of the landing gear bracket.
Secure the landing gear into place using 2 screws (F) and 2 nuts (G). Repeat
installation for opposite strut.
4. Connect both hooks (H) to the holes located on the strut behind the tire.
5. Align the bottom of the landing gear suspension spring (I) to the second hole
of the front landing bracket. Secure it into place with the screw (F) and nut (G).
Repeat installation for opposite strut.
Bag K
(D) 2 x 3mm
Set Screw
Bag B
(F) 2 x 16mm
Button head hex machine
Bag C
(G) 2mm
Lock Nut
I
Bag B
(F) 2 x 16mm
Button head hex machine
B
A
Bag K
(C) Wheel collar
H
Bag C
(G) 2mm
Lock Nut
EN
E
5