Center Of Gravity (Cg); Control Horn And Servo Arm Settings; In Flight Trimming - Horizon Hobby E-flite Carbon-Z Cub SS Instruction Manual

EN

Center of Gravity (CG)

The CG location is measured from the leading edge of the wing at the root. This CG
location has been determined with the recommended Li-Po battery
(SPMX40006S50) installed in the middle of the battery compartment.

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. These settings, in conjunction with the low rate transmitter settings, are
intended for the first time pilot through the intermediate level pilot to help ensure a
successful flight.
Fly the aircraft at these factory settings before making changes. After flying, or for
advanced level pilots you may choose to adjust the linkage positions to increase
control response.

In Flight Trimming

During your first flight, trim the aircraft for level flight at 3/4 throttle with flaps and
gear up. Make small trim adjustments with your transmitter's trim switches to
straighten the aircraft's flight path.
After adjusting trim do not touch the control sticks for 3 seconds. This allows the
receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect flight performance.
16
Factory Settings
Control Horns
Aileron
Elevator
Rudder
Flaps
3 Seconds
Carbon-Z Cub SS
105-120mm
back from leading edge at
the root.
Servo Arms