Horizon Hobby E-flite Carbon-Z Cub SS Instruction Manual page 9

Model Assembly
(Continued)
Wing Installation
Before each flight, ensure all wing connectors and fasteners are secure.
Assemble both wings using the following steps. (Only the right wing shown)
1. Install 6 vortex generators (A) in the wing channels (B) by using the installed
double-sided tape.
2. Install the jury strut (D) on the wing mounts using 2 screws (E) and
2 lock nuts (F).
TIP: DO NOT overtighten lock nuts on the screws. Ensure the vertical brackets
can pivot freely on the wing mounts.
3. Install the wide front strut (G) on the front strut mounts using a screw (H) and
lock nut (F).
4. Install the narrow rear strut (J) on the rear strut mount using a screw (H) and
lock nut (F).
TIP: DO NOT overtighten lock nuts on the screws. Ensure the struts can pivot
freely in the strut mounts.
5. Attach the vertical bracket to the struts using 2 pins (I) and 2 R-clips (K).
Bag F
(E) 3 x 12mm
Button head hex machine
G
Bag L
Bag J
(H) 3 x 18mm
Button head hex machine
A
B
D
Bag I
(F) 3 mm
Lock Nut
J
Bag L
(I)
Bag I
(F) 3 mm
Lock Nut
EN
(K)
9