Model Assembly
(Continued)
Horizontal Tail Installation
1. Slide the horizontal stabilizer rod (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer as shown. Ensure the
control horn faces down.
3. Install 4 screws (B) in the front and rear holes in the bottom of the
horizontal tail.
4. Attach the ball link (C) to the elevator control horn's middle hole using the
included nut (D) and screw (E).
5. Ensure the elevator servo arm is in the correct position, then adjust the linkage
to center the elevator.
When needed, disassemble in reverse order.
TIP: Use needle-nose pliers or ball link pliers (RVO1005) to remove or install a
link on a control horn.
Bag C
(D) 2mm
Lock Nut
EN
A
Bag F
(B) 3x12mm
Button head hex machine
C
Bag E
(E) 2x10mm
Hex head machine
7