Horizon Hobby E-flite Carbon-Z Cub SS Instruction Manual page 8

EN
Model Assembly
(Continued)
Motor and Propeller Installation
1. Correctly align and connect the motor wire colors with the ESC wires.
2. Install the motor (A) with pre-installed X-mount (B) on the fuselage using 4
screws (C) and 4 lockwashers (D). Align the motor wires to face down and
position them in the pocket below the motor location. Ensure that the wires are
out of the way of the spinning motor.
3. Install the collet (E), and back plate (F) on the motor shaft (G).
4. Install the cowling (H) on the fuselage using 2 screws (I).
5. Install the spinner back plate (J), propeller (K) and nut (L) on the collet. Use a
tool to tighten the nut.
IMPORTANT: The propeller size numbers (15 x 7) must face out from the motor
for correct propeller operation. Ensure the nut holds the propeller tightly without
damaging the propeller.
6. Install the spinner (M) on the collet using the screw (N).
Disassemble in reverse order. Not all wiring shown.
NOTICE: If the propeller is not balanced, the aircraft may vibrate, causing the
stabilization system to not operate correctly and/or decrease the life
of the servos.
Horizon Hobby does not warrant replacement if the servos are used under
extreme vibration or the stabilization system is used with an unbalanced propeller.
For more information, view the propeller balancing video at
www.horizonhobby.com.
TIP: We recommend removal of the propeller before any radio system setup or
transport of your aircraft.
8
Bag G
(C) 3x19mm
Hex head self tapping
H F
E
Bag D
(I) 2.5x10mm
Button head hex self tapping
L
M
K
Bag H
(N) 2.5x8mm
Pan head hex machine
Carbon-Z Cub SS
B
A
G
Bag G
(D) 3mm
Lock washer
J