Horizon Hobby E-flite Carbon-Z Cub SS Instruction Manual page 10

EN
Model Assembly
(Continued)
Wing Installation (Continued)
1. Slide the wing tube (A) into the fuselage.
2. Install the left and right wing (B and C) onto the wing tube.
3. Connect the servo connectors (D) to the respective connectors on the fuselage
(connectors are marked AIL or FLAP) and slide the wing into the slot of the
fuselage.
NOTICE: Always put excess servo connector wire into the pocket of the wing to
prevent pinching of wires or other damage.
4. Secure the wings on the fuselage using 4 thumb screws (E) in the holes on the
top of the wings.
5. Install the 2 antenna (F) on top of the two rear thumb screws by pressing them
onto the thumb screw.
6. Connect the left and right wing struts to the fuselage mounts (G) using 4 pins
(H) and 4 R-clips (I).
Removal
We recommend removing the wings from the fuselage for storage or transport of
the aircraft.
TIP: Remove the jury strut pins and clips from the struts to pivot the brackets
and struts down to the wings. Wing struts do not need to be disassembled to be
removed.
NOTICE: Always secure loose parts after removal. DO NOT FLY if parts are
missing or damage may result.
10
Bag K
(F) Antenna Cap
A
D
C
G
Bag L
(I)
Carbon-Z Cub SS
B
Bag K
(E) 3 x 25mm
Thumb Screw
Bag L
(H)