Tesla RoboStar iQ600 Manual page 76

Lightly dampen the mop cloth with water and squeeze the water out of it so that it does not drip. Install the mop cloth on the mop module and
attach it to the robotic vacuum cleaner.
 Remove the mop module after cleaning.
 Do not leave the vacuum cleaner standing still or with water residue in the water tank to prevent water from spilling on the floor.
 Do not use wet wipe on the carpet. In the TESLA application, you can create a "Forbidden Area" or a "Virtual Wall" that the robotic vacuum
cleaner will not clean / wipe with water.
 We recommend that you pour out the remaining water from the water tank after each mop to prevent the drain hole from being blocked by
calcium deposits.
 If the mop is dirty after cleaning, you can carefully wash it in lukewarm water.
 We recommend wiping the floor with clean water, as the cleaning agent may cause foaming and thus worsen the dripping of water on the
mop or cause smudges on the floor after it has dried.
ROUTINE MAINTENANCE OF ROBOTIC VACUUM CLEANER
A Air outlet
B Loudspeaker
C Laser signal transmitter
D Ultrasonic range sensor
E Impact sensors
F Wall following sensor
G Cliff sensors
H Front wheel
I Side brush
J Battery cover
K Main central brush
L Frame of the main central brush
M Driving wheel
N Air filter