Smartstart/Xl202 Installation Notes - Directed DB3 Installation Manual

SmartStart/XL202 installation notes

The DB3 Remote Start Ready (RSR) solution offers three (3) configuration options to control your system: 3x OEM Lock Remote
Start Activation, RF Kit or SmartStart (both sold separately). This section provides specific installation information for SmartStart and
XL202.
SmartStart revision A
SmartStart is optional and not included. It MUST be purchased separately.
SmarStart
Cable
The modules must be connected in a specific order. Refer to "Module programming" for more information.
SmartStart revision B
SmarStart
Cable
SmartStart is optional and not included. It MUST be purchased separately.
SmarStart
Cable
SmarStart
Cable
SmarStart
Cable
The modules must be connected in a specific order. Refer to "Module programming" for more information.
D2D
XOVER Cable
RF System
SmarStart
Cable
The optional XL202 and antenna are not included and MUST be purchased separately.
D2D
XOVER Cable
D2D
XOVER Cable
1. Use the D2D Crossover (XOVER) cable that is provided with XL202, and NOT the one in the DB3 package.
2. The modules must be connected in a specific order. Refer to "Module programming" for more information.
RF System & PKE combination
Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.
RF System, PKE & SmartStart BT combination
Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.
15
403.AUDI02 3.10 2015 Audi A4 (Smart Key w/PTS)
©2021 VOXX•DEI LLC. All rights reserved.
Configuration wires (White & Brown or Blue)
Cut Brown or Blue loop
4 pins
2 pins,
not used
Configuration wires (White & Brown or Blue)
Cut Brown or Blue loop
D2D (4 pins, white)
4 pins
Configuration wires (Gray & White)
2 pins,
Connect Gray wire to (-) Ground
not used
Configuration wires (White & Brown or Blue)
5 pins
Cut Brown or Blue loop
D2D (4 pins, white)
4 pins
4 pins
2 pins,
not used
Configuration wires (Gray & White)
2 pins,
Connect Gray wire to (-) Ground
not used
D2D (4 pins, white)
5 pins
D2D (4 pins, white)
4 pins
2 pins,
not used
Configuration wires (Gray & White)
Connect Gray wire to (-) Ground
D2D (4 pins, white)
5 pins
4 pins
2 pins,
not used
D2D (4 pins, white)
THIS SIDE UP
THIS SIDE UP
THIS SIDE UP