Smartstart/Xl 202 Installation Notes - Directed Xpresskit DBALL2 Installation Manual

Platform: DBALL2
Firmware FORD3 emote Start : R
SmartStart/ XL 202 Installation Notes
Th e DBALL Remote Start Ready (
Lock Remote Start Activation,
information for SmartStart and
SmartStart Revision A
SmartStart is optional and not included. It
Configuration Wires (White & Brown or Blue)
DBALL/
DBALL 2
CABLE
D2D (4 pins, white)
The modules must be connected in a specific order. Refer to the
SmartStart Revision B
SmartStart is optional and not included. It
DBALL/
DBALL 2
CABLE
D2D (4 pins, white)
The modules must be connected in a specific order. Refer to the
RF Kit
The optional XL 202 and antenna are not included and
DBALL/
DBALL 2
XOVER
1. Use the D2D Crossover (
2. The modules must be connected in a specific order. Refer to the
RF Kit & PKE Combination
Refer to the Passive Keyless Entry (
RF Kit , PKE & SmartStart
Refer to the Passive Keyless Entry (
Ready (R
RSR ) solution offers three (3) configuration options to control your system; 3x
RF Kit or SmartStart (all sold separately). s
XL 202.
MUST be purchased separately.
Cut Brown or Blue Loop
4 pins
2 pins,
not used
MUST be purchased separately.
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
4 pins
2 pins,
not used
LED
LED
XL202
Prog.
Button
XOVER ) cable that is provided with
PKE ) Installation Guide (N2102T) for detailed wiring information.
BT Combination
PKE ) Installation Guide (N2102T) for detailed wiring information.
SR Installation )
This section provides specific installation
OR
SmartStart
LED
Module Programming section for more information.
THIS SIDE UP
Module Programming section for more information.
MUST be purchased separately.
XL 202, and NOT the one in the
Module Programming section for more information.
DBALL package.
© 2017 Directed. All rights reserved.
Rev.: 20170908
Page 9
OEM