Table of Contents
Advertisement
468
7-2. Steps to take in an emergency
■
If the tire is inflated to more than the specified air pressure
Disconnect the hose from the valve.
1
Install the air release cap to the end of
2
the hose and push the protrusion on the
air release cap into the tire valve to let
some air out.
Disconnect the hose from the valve, remove the air release cap from the
3
hose and then reconnect the hose.
Turn the compressor switch on and wait for several seconds, and then turn
4
it off. Check that the air pressure indicator shows the specified air pressure.
(P. 515)
If the air pressure is under the designated pressure, turn the compressor
switch on again and repeat the inflation procedure until the specified air
pressure is reached.
■
The valve of a tire that has been repaired
After a tire is repaired with the emergency tire puncture repair kit, the valve
should be replaced.
■
Note for checking the emergency tire puncture repair kit
Check the sealant expiry date occasionally.
The expiry date is shown on the bottle. Do not use sealant whose expiry date
has already passed. Otherwise, repairs conducted using the emergency tire
puncture repair kit may not be performed properly.
Advertisement
Table of Contents
