Table of Contents
Advertisement
Connect the jumper cables according to the following procedure:
3
1
Connect a positive jumper cable clamp to the positive (+) battery
terminal on your vehicle.
2
Connect the clamp on the other end of the positive cable to the
positive (+) battery terminal on the second vehicle.
3
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
4
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the 12-volt
battery and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed
4
slightly and maintain at that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Maintain the engine speed of the second vehicle and start the
5
hybrid system of your vehicle by turning the power switch to ON
mode.
Make sure the "READY" indicator comes on. If the indicator light
6
does not come on, contact your Toyota dealer.
7-2. Steps to take in an emergency
4
3
1
2
493
7
Advertisement
Table of Contents
