Table of Contents
Advertisement
466
7-2. Steps to take in an emergency
Temporarily store the bottle in the luggage compartment while it is
18
connected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
19
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving, stop your vehicle
20
in a safe place on a hard, flat
surface
and
repair kit.
Remove the air release cap from
the hose before reconnecting the
hose.
Turn the compressor switch on and wait for several seconds, then
21
turn it off. Check the tire inflation pressure.
1
If the tire inflation pressure is
under 130 kPa (1.3 kgf/cm
or bar, 19 psi): The puncture
cannot be repaired. Contact
your Toyota dealer.
2
If the tire inflation pressure is
130 kPa (1.3 kgf/cm
19 psi) or higher, but less
than the specified air pres-
sure: Proceed to step
3
If the tire inflation pressure is the specified air pressure
(P. 515): Proceed to step
Turn the compressor switch on to inflate the tire until the specified
22
air pressure is reached. Drive for about 5 km (3 miles) and then
perform step
reconnect
the
2
2
or bar,
.
22
23
.
20
.
Advertisement
Table of Contents
