Table of Contents
Advertisement
Notes:
1: BuiltIn StepUp converter to 12V, max. 500 mA
2: Backlight Enable Signal, normally active low, mount R1 instead of R2 for active high signal
3: Power supply for TFT panel, 5V, max. 500 mA
4: Normally not connected, for PWM backlight control mount R118 0Ohm
Table 5-12: Kontron cables for display connection
For connection of ...
TFT PrimeView PM070WL4 (video signal and backlight only)
TFT PrimeView PM070WL4 (touch)
DVI monitor
For a detailed description of the LVDS JILI interface refer to the JILI documentation on Kontron's
webpage.
5.7
VGA Port (X8)
The integrated graphics of the COM Express™ module can be used by the analog DSUB15 VGA connector
X8. Please check if the VGA port is supported by the used COM Express™ module.
Table 5 13: Pinning of X8
Connector: CON-MOLEX-53261-0671; Molex 53261-0671
Header
Cable:
KAB-VGA-2; 96053-0000-00-0
Kontron User's Guide nanoETXexpress-HMI
Baseboard (ePDAnano)
KAB-ADAPT-LVDS; 61032 + KAB-JILI30-TSLD01; 62518
Separate touch adapter required /
complete solution available
ADA-LVDS-DVI; 96007-0000-00-1
PIN
Signal
1
HSYNC
2
VSYNC
3
GND
4
BLUE
5
GREEN
6
RED
22
5 Connector and feature description
Cable or adapter
Function
VGA_HSYNC
VGA_VSYNC
Ground
VGA_BLUE
VGA_GREEN
VGA_RED
Note
Advertisement
Table of Contents
