GE LPS-D Instruction Manual page 401

APPENDIX C
Refer to Chapter 2 for a detailed description of the setpoints listed in the table below. The formats, ranges and
units for various setpoints are as described in the Instruction Book but for the following exceptions in these
notes. Refer to Appendix B, for a description of the procedure to View/Change the LPS-D setpoints.
Table C–7: POINT LIST: OBJECTS 40 & 42 (Sheet 1 of 9)
INDEX DESCRIPTION
0 Edit Settings Group Number
1 Z1 Phase Distance
2 Z1 Phase Reach
3 Z1 Phase Level Detector
4 Z1 Ground Distance
5 Z1 Ground Reach
6 Z1 Ground Characteristic
7 Z1 Ground React. Mho Supervision Reach
8 Z1 Ground K0
9 Z1 Ground Level Detector
10 Z1 Blocking Supervision
11 Z1 Ground Characteristic Angle (LPSQUAD)
...Reserved...(ALPS/LPS)
12 Z1 Right Resistive Ground Blinder (LPSQUAD)
...Reserved....(ALPS/LPS)
13 Z2 Phase Distance
14 Z2 Phase Reach
15 Z2 Phase Characteristic Angle
16 Z2 Ground Distance
17 Z2 Ground Characteristic
18 Z2 Ground Reach
19 Z2 Ground Characteristic Angle
20 Z2 Timers
21 Z2 Phase Timer
22 Z2 Ground Timer
23 Z2 Right Resistive Ground Blinder (LPSQUAD)
...Reserved...(ALPS/LPS)
24 Z3 Phase Distance
25 Z3 Phase Reach
26 Z3 Phase Characteristic Angle
27 Z3 Ground Distance
28 Z3 Ground Reach
29 Z3 Ground Characteristic Angle
GE Power Management
C.3.6 ANALOG OUTPUT, ANALOG OUTPUT BLOCK
ANALOG OUTPUT (OBJECT 40)
ANALOG OUTPUT BLOCK (OBJECT 41)
LPS-D Line Protection System
C.3 POINT LISTS
FORMAT / UNITS REMARKS
Note 1
C
C-
23