HBM T40B Mounting Instructions page 8

Safety instructions
Industry Canada for Option 7, Code U
This device complies with Industry Canada standard RSS210.
This device complies with Industry Canada license−exempt RSS stan­
dard(s).Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme aux norme RSS210 d'Industrie Canada.
Cet appareil est conforme aux normes d'exemption de licence RSS d'Industry
Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1)cet
appareil ne doit pas causer d'interférence et (2) cet appareil doit accepter toute
interférence, notamment les interférences qui peuvent affecter son fonction­
nement.
Appropriate use
The T40B torque flange is used exclusively for torque, angle of rotation and
power measurement tasks within the load limits stipulated in the specifications.
Any other use is not appropriate.
Stator operation is only permitted when the rotor is installed.
The torque flange may only be installed by qualified personnel in compliance
with the specifications and with the safety requirements and regulations of
these mounting instructions. It is also essential to observe the applicable legal
and safety regulations for the application concerned. The same applies to the
use of accessories.
The torque flange is not intended for use as a safety component. Please also
refer to the "Additional safety precautions" section. Proper and safe operation
requires proper transportation, correct storage, siting and mounting, and care­
ful operation.
Load carrying capacity limits
The data in the technical data sheets must be complied with when using the
torque flange. In particular, the respective maximum loads specified must
never be exceeded. For example, the values stated in the specifications must
not be exceeded for
S limit torque,
6 T40B
A03452_15_X00_00 HBM: public