Mechanical installation
5.5
Installing the rotor
Tip
Usually the rotor type plate is no longer visible after installation. This is why we
include with the rotor additional stickers with the important characteristics,
which you can attach to the stator or any other relevant test‐bench compo
nents. You can then refer to them whenever there is anything you wish to
know, such as the shunt signal. To explicitly assign the data, the identification
number and the size are engraved on the rotor flange, where they can be seen
from outside.
Notice
Make sure during installation that you do not damage the measuring zone
marked in Fig. 5.1 by using it to support tools, or knocking tools against it when
tightening screws, for example. This can damage the transducer and produce
measurement errors, or even destroy the transducer.
20
A03452_15_X00_00 HBM: public
T40B