ICS ELECTRONICS 4863 Manual page 87

Notes:
1. Parameter enclosed by [ ] - denotes factory default
2. Parameter enclosed by ( ) - denotes power on default
3. SCPI name ends with ? - denotes query only
4. Unless otherwise noted SCPI command is also a query
5. Keyword enclosed by [ ] - denotes optional use
6. Only a configuration command that has one of its parameters enclosed by [ ] can change
its parameter setting and have this setting stored in the 4863's E
command).
7. The format for a SCPI list is (@ 1,2, n) or (@ 1:n)
8. Numeric entries conform to IEEE-488.2 section 7.7.2.4 for decimal numeric param-
eters.
9. ASCII formatted data is a series of decimal values (0-255) for each byte separated by
commas. e.g. 64, 132, 8
10. The CAL:DATe commands stores the CAL:IDN and CAL:DATe parameters in the
3
4863's E
11. The CAL:DEFault command resets the Flash to it factory settings. Caution - All user
settings will be overridden by this command.
12. Most parameters can be output in various numeric formats (radix). The parameters
with decimal 0-255 value ranges may also be output as HEX using #h00-#hFF or
Binary using #b00000000-#b11111111. Conversely, the parameters shown with HEX
(#h) values can also be output in Decimal.
13. Serial interface always responds to every command with a response message. For
direct interface to a terminal or to a PC running a terminal emulation program, the serial
interface also supports echo-to-host and backspace characters. Echo-to-host available
on RS-232 interface only. Backspace character removes the preceding serial
character.
The serial interface generates the following prompts when ready for the next serial
command.
Echo-back
Mode
On
Off
TABLE 3-2 SCPI COMMAND TREE (CONT'D)
2
PROM.
CTRL-E turns echo On.
CTRL-F turns echo Off. (Power-on default condition)
RS-232
Prompt
CR LF > sp
>LF
RS-485 Message
Prompt Terminator
n/a CR LF
>LF LF
3-20
2
PROM (with the *SAV