ICS ELECTRONICS 4863 Manual page 82

TABLE 3-1
COMMAND
*RST Cont'd
*SAV <value> Save
*SRE <value> Service
Request
Enable
*SRE? Service Request
Enable Query
*STB? Read Status Byte
*TRG Device Trigger
*TST? Self-Test Query
*WAI Wait-to-continue
IEEE-488.2 COMMON COMMANDS
(CONTINUED)
NAME
Status Byte and ESR Register. Disables
the trigger function and pulses the Reset
output signal.
Saves current 4863 configuration in the
2
E PROM. *SAV 0 saves the current set-
ting as the new power on setting.
<value>=0
Sets the "Service Request Enable Regis-
ter" to <value>, an integer between 0 and
255. The value of bit six is ignored be-
cause it is not used by the Service Request
Enable Register. <value> is an integer
whose binary equivalent corresponds to
the state (1 or 0) of bits in the register. If
<value> is not between 0 and 255, an
Execution Error is generated.
4863 returns the <value> of the "Service
Request Enable Register" (with bit six set
to zero). <value> is an integer whose
binary equivalent corresponds to the state
(1 or 0) of bits in the register.
4863 returns the <value> of the "Status
Byte" with bit six as the "Master Sum-
mary" bit. <value> is an integer whose
binary equivalent corresponds to the state
(1 or 0) of bits in the register.
Pulses the Trigger output line when trig-
gers have been enabled.
Queries the results of the last self test. A
zero response indicates no failures. Other
responses are listed in Table 5-1.
Prevents the 4863 from executing any
further commands or queries until the No-
Operation-Pending flag is TRUE.
3-15
DESCRIPTION
3