ICS ELECTRONICS 4863 Manual page 160

1. Select the appropriate cutout from Figure A-11
2. Locate a blank area or the host's rear panel. Leave
enough room for the flat ribbon cable bend radius.
3. Machine the cutouts.
4. Install the Connector/Switch Assembly from the inside.
Use the metric studs and two thin lock washers to hold the
assembly to the panel.
5. Route the flat ribbon cable to the 4803 so it avoids any
high RFI or electrical noise area. Plug the cable into J2.
6. Mark or silkscreen the switch functions onto the rear
panel as shown in Figure A-10. Identify the 5 address
rockers as shown and switch 6 for your application.
BUS ADDRESS
1 8 4 2 1 - - -
6
Figure A-10
0.060 typ.
Space letters
on rockers,
0.1 centers typ.
Switch Silkscreen Detail
A-29
A3