Table of Contents
Advertisement
Available languages
Available languages
SPECIFICATIONS
Dimension (WxDxH)
Width with door open 90°
Width with door open 135°
Weight
Power requirements
Power cord length
INSTALLATION
UNPACK
WARNING
Fire or Explosion Hazard
•
Do not puncture refrigerant tubing.
•
Follow handling instructions carefully.
•
Flammable refrigerant used.
•
Failure to do so can result in death, explosion or fire.
IMPORTANT: Remove ALL exterior and interior packing materials
including the foam packing between the exterior condenser and the
refrigerator cabinet.
DOOR REMOVAL
(ONLY IF NEEDED)
Measure the refrigerator to make sure it will fit through the doorway.
If the refrigerator cannot pass easily through the doorway, follow the
instructions to remove the two refrigerator compartment doors and the
front panels of the flex temperature and freezer drawers.
WARNING
Electrical Shock Hazard
•
Disconnect power before removing doors.
•
Reconnect ground wire before operating.
•
Failure to do so could result in death or electric shock.
35.8" x 31.2" x 69.9"
(91 x 79 x 178 cm)
44.2" (112 cm)
64.4" (164 cm)
379 lbs. (172 kg)
115 V ~ 60 Hz, 15A minimum requirement
66.9" (170 cm)
11
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the MRQ22D7AST and is the answer not in the manual?
Questions and answers
My control panel on the drawer has gone out. Due to this, neither ice maker is working and we can't adjust temps on anything. Is there a way to reset this? We have tried unplugging the fridge for 30 seconds. What else can I try? If I have to replace the control panel on the drawer, how do I do that?
How do you correct a E6 code
The E6 error code on the Midea MRQ22D7AST refrigerator indicates a communication failure between the main board and the display board. To fix this issue, try the following steps:
1. Power Cycle the Refrigerator – Unplug the refrigerator from the power source for a few minutes, then plug it back in and check if the error clears.
2. Check Connections – Ensure that the wiring connections between the main board and the display board are secure and undamaged.
3. Reset the Control Panel – If the refrigerator has a reset function, use it to restart the system.
4. Contact Customer Support – If the error persists, contact Midea customer service or a qualified technician for further diagnosis and repair.
If the refrigerator is under warranty, consider requesting service from an authorized Midea technician.
This answer is automatically generated
We are seeing a EO on the display panel. We hold hold the control lock for seconds and it goes away. However it returns. Not sure what the EO means and how to get rid of it.
The E0 error code on the Midea MRQ22D7AST display panel indicates a freezer ice maker initialization failure. To resolve this issue, try the following steps:
1. Power Cycle the Appliance – Unplug the refrigerator for a few minutes and then plug it back in to reset the system.
2. Check the Ice Maker – Ensure the ice maker is properly connected and not obstructed.
3. Inspect for Ice Blockages – Remove any ice buildup that may be preventing the ice maker from initializing.
4. Verify Water Supply – Ensure the water line is connected and supplying water to the ice maker.
5. Contact Support – If the issue persists, contact Midea customer service or an authorized technician for further assistance.
If the error continues, professional service may be required.
This answer is automatically generated