Table of Contents
Advertisement
Available languages
Available languages
WATER SUPPLY REQUIREMENTS
A cold water supply with water pressure between 30 and 100 psi (207 and
689 kPa) is required to operate the water dispenser and ice maker. If
you have questions about your water pressure, call a licensed, qualified
plumber.
IMPORTANT: Operation outside the water pressure range may cause
malfunction and severe, damaging water leaks.
NOTE: If the water pressure is less than what is required, the flow of water
from the water dispenser could decrease or ice cubes could be hollow or
irregularly shaped.
Reverse Osmosis Water Supply (if applicable)
IMPORTANT: The pressure of the water supply coming out of a reverse
osmosis system going to the water inlet valve of the refrigerator needs to
be between 30 and 100 psi (207 and 689 kPa).
If water pressure is too low:
Check to see whether the sediment filter in the reverse osmosis system is
blocked. Replace the filter if necessary.
Allow the storage tank on the reverse osmosis system to refill after
heavy use. The tank capacity could be too small to keep up with the
requirements of the refrigerator.
If your refrigerator has a water filter, it may further reduce the water
pressure when used in conjunction with a reverse osmosis system.
Remove the water filter.
9
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the MRQ22D7AST and is the answer not in the manual?
Questions and answers
My control panel on the drawer has gone out. Due to this, neither ice maker is working and we can't adjust temps on anything. Is there a way to reset this? We have tried unplugging the fridge for 30 seconds. What else can I try? If I have to replace the control panel on the drawer, how do I do that?
How do you correct a E6 code
The E6 error code on the Midea MRQ22D7AST refrigerator indicates a communication failure between the main board and the display board. To fix this issue, try the following steps:
1. Power Cycle the Refrigerator – Unplug the refrigerator from the power source for a few minutes, then plug it back in and check if the error clears.
2. Check Connections – Ensure that the wiring connections between the main board and the display board are secure and undamaged.
3. Reset the Control Panel – If the refrigerator has a reset function, use it to restart the system.
4. Contact Customer Support – If the error persists, contact Midea customer service or a qualified technician for further diagnosis and repair.
If the refrigerator is under warranty, consider requesting service from an authorized Midea technician.
This answer is automatically generated
We are seeing a EO on the display panel. We hold hold the control lock for seconds and it goes away. However it returns. Not sure what the EO means and how to get rid of it.
The E0 error code on the Midea MRQ22D7AST display panel indicates a freezer ice maker initialization failure. To resolve this issue, try the following steps:
1. Power Cycle the Appliance – Unplug the refrigerator for a few minutes and then plug it back in to reset the system.
2. Check the Ice Maker – Ensure the ice maker is properly connected and not obstructed.
3. Inspect for Ice Blockages – Remove any ice buildup that may be preventing the ice maker from initializing.
4. Verify Water Supply – Ensure the water line is connected and supplying water to the ice maker.
5. Contact Support – If the issue persists, contact Midea customer service or an authorized technician for further assistance.
If the error continues, professional service may be required.
This answer is automatically generated