Electric Safety; Electrostatic Charging (Formation Of Sparks Or Flames) - WAGNER Brillux PROSPRAY 39 SELECT Owner's Manual

1.2

Electric Safety

Electric models must be earthed. In the event
of an electrical short circuit, earthing reduces
the risk of electric shock by providing an escape
wire for the electric current. This product is
equipped with a cord having an earthing wire
with an appropriate earthing plug. Connection
to the mains only through a special feed point,
e.g. through an error protection insallation with
INF < 30 mA.
DANGER — Work or repairs at the
electrical equipment may only be
carried out by a skilled electrician.
No liability is assumed for incorrect
installation. Switch the unit off.
Before all repair work, unplug the
power plug from the outlet.
Danger of short-circuits caused by water
ingressing into the electrical equipment. Never
spray down the unit with high-pressure or high-
pressure steam cleaners.
Work or repairs at the electrical equipment:
These may only be carried out by a skilled
electrician. No liability is assumed for incorrect
installation.
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agent or
a similarly qualified person in order
to avoid a safety hazard.
ProSpray 39 Select
GB
1.3 Electrostatic charging (formation of
sparks or flames)
Electrostatic charging of the unit
may occur during spraying due
to the flow speed of the coating
material. These can cause sparks
and flames upon discharge. The
unit must therefore always be
earthed via the electrical system.
The unit must be connected to an
appropriately-grounded safety
outlet.
An electrostatic charging of spray guns and the
high-pressure hose is discharged through the
high-pressure hose. For this reason the electric
resistance between the connections of the
high-pressure hose must be equal to or lower
than 1 MΩ.
33
Safety Regulations