WAGNER Brillux PROSPRAY 39 SELECT Owner's Manual page 33

PREVENTION:
• High-pressure hoses must be checked
thoroughly before they are used.
• Replace any damaged high-pressure hose
immediately.
• Never repair defective high-pressure hoses
yourself!
• Avoid sharp bends and folds: the smallest
bending radius is about 20 cm.
• Do not drive over the high-pressure hose.
Protect against sharp objects and edges.
• Never pull on the high-pressure hose to
move the device.
• Do not twist the high-pressure hose.
• Do not put the high-pressure hose into
solvents. Use only a wet cloth to wipe
down the outside of the hose.
• Lay the high-pressure hose in such a way
as to ensure that it cannot be tripped over.
i Only use WAGNER original-high-
pressure hoses in order to ensure
functionality, safety and durability.
ProSpray 39 Select
GB
HAZARD: EXPLOSION OR FIRE
Solvent and paint fumes can
explode or ignite. Severe injury
and/or property damage can occur.
PREVENTION:
• Do not use materials with a flashpoint
below 38° C (100° F). Flashpoint is the
temperature at which a fluid can produce
enough vapors to ignite.
• Do not use the unit in work places which
are covered by the explosion protection
regulations.
• Provide extensive exhaust and fresh air
introduction to keep the air within the
spray area free from accumulation of
flammable vapors.
• Avoid all ignition sources such as static
electricity sparks, electrical appliances,
flames, pilot lights, hot objects, and sparks
from connecting and disconnecting power
cords or working light switches.
• Do not smoke in spray area.
• Place sprayer sufficient distance from
the spray object in a well ventilated area
(add more hose if necessary). Flammable
vapors are often heavier than air. Floor
area must be extremely well ventilated.
The pump contains arcing parts that emit
sparks and can ignite vapors.
• The equipment and objects in and around
the spray area must be properly grounded
to prevent static sparks.
• Use only conductive or earthed high
pressure fluid hose. Gun must be earthed
through hose connections.
• Power cord must be connected to a
grounded circuit (electric units only).
• Always flush unit into separate metal
container, at low pump pressure, with
spray tip removed. Hold gun firmly against
side of container to ground container and
prevent static sparks.
• Follow material and solvent manufacturer's
warnings and instructions. Be familiar with
the coating material's MSDS sheet and
technical information to ensure safe use.
• Use lowest possible pressure to flush
equipment.
31
Safety regulations