GB
4
OPERATION
4.1
General
General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
S
Place Miggytrac 1001 at the weld joint.
S
Adjust the arms so that the carriage runs diagonally towards the edge of the
plate.
S
When the magnet is activated the friction between the drive wheels and the
foundation increases, resulting in a more stable carraiage, despite its low weight.
The magnet is switched On/Off using a twist grip on top of the chassis.
4.2
Start / stop of carriage
4.3
Welding
Selection whether to start/stop the connected feed unit with the switch on the
carriage or not.
4.4
Magnet
Twist grip switching the built--in magnet On/Off (raising and lowering). When the
carriage is not in use the magnet should be switched off.
fhc1o1ea
Travel direction, left
On
On
- - 13 - -
Stop
Travel direction, Right
Off
Off