Ethernet Networking Skills; Pole Or Tower Mount Guidelines - Cambium Networks XV3-8 Hardware Installation Manual

Ethernet networking skills

The installer must have the ability to configure IP addressing on a PC and to set up and control products
using a web browser interface.

Pole or tower mount guidelines

If you need to install AP to a metal tower or pole, then in addition to the general protection
requirements, follow the below requirements:
•
Ensure that the position of the equipment is lower than the top of the tower or its lightning air
terminal.
•
Ensure that the metal tower or pole is correctly grounded.
•
Install a grounding kit at the first point of contact (top), between the drop cable and the tower.
•
Install a grounding kit at the bottom of the tower, near the vertical to horizontal transition point.
Note If grounding kit is installed, ensure the grounding kit is bonded to the tower or Tower
Ground Bus Bar (TGB).
Connection examples of pole or tower installations are shown in below figure.
About This User Guide
Enterprise Wi-Fi AP Hardware Installation Guide
8