Training; Power Density Exposure Limit - Cambium Networks XV3-8 Hardware Installation Manual

Note
There should be a drip loop immediately at the Ethernet port entrance going to the AP.

Training

The installer needs to have basic competence in radio and IP network installation. The specific
requirements applicable to the Cambium Networks Enterprise Wi-Fi AP must be gained by reading this
User Guide and by performing sample setups at base workshop before live installments.

Power density exposure limit

This section includes the following topics:
•
Calculation of power density and distance
•
Calculated distances and power compliance margins
Install the radios for the platform family of wireless solutions so as to provide and maintain the minimum
separation distances from all persons.
The applicable FCC power density exposure limit for RF energy in the 2.4 and 5 GHz frequency bands is
1 mW/cm2.
About This User Guide
Figure 2 Grounding and lightning protection on wall
Enterprise Wi-Fi AP Hardware Installation Guide
10