Pilz PSEN op4F-A Series Operating Manual page 74

OPERATING MANUAL
Blanking valid
(OSSD ON)
Normal
Blanking invalid
operating
(OSSD OFF)
mode
Blanking only
Tolerance BCM active
Muting active
Override active
Normal
operating
Override status
mode
Muting only
Override timing error
Lamp error
OSSD error
Microprocessor error
Lens error
EDM error
Restart error
Error
information
Communication error
BCM Configuration error
ACM Configuration error
Critical error
A critical error cannot be eliminated via a RESET.
The light curtain must be switched on and off. If the error should persist, please contact Pilz
customer services.
74
PSEN op4F/H-A series
Blanking zones not observed.
Re-configure blanking (teach in
if BCM)
Check the actual resolution for
the light curtain and the intended
activation of the tolerance
function.
If the OSSDs switch off
unintentionally and during
active muting, check the partial
muting configuration.
Activate the override button to
bridge OSSDs to light
Check and repeat the override
activation sequence.
Check the override
connections.
Check the lamp connections
and check for any potential
defects on the lamp.
Activate RESET.
If the problem should persist,
please contact Pilz customer
services.
Activate RESET.
If the problem should persist,
please contact Pilz customer
services.
Activate RESET.
If the problem should persist,
please contact Pilz customer
services.
Activate RESET.
Check the EDM feedback line
and the EDM configuration.
Check connection RESTART
/RESET/REALIGN.
Activate RESET.
Check the cascading
connection and check that the
terminator cap is installed
correctly.
Perform basic configuration
again.
If the problem should persist,
please contact Pilz customer
services.
Perform advanced configuration
again.
If the problem should persist,
please contact customer
services.
Switch light curtain on/off.
If the problem should persist,
please contact Pilz customer
services.
1003067-EN-04