Figure 45 Removing The Fan - Agilent Technologies 6000 Series Service Manual

5 Replacing 6000A Assemblies
Fan
Fan mount
Fan cable
126
4 Slide the fan mount to the side to remove the 4 retainer
hooks from their keyholes and lift out.
It may help to push on each of the hooks to keep from tearing
them.
5 Peel the rubber fan mount off the corners of the fan.
Figure 45 Removing the fan
6 Reverse this procedure to replace the fan assembly.
When re-installing, note the position of the tab on the fan
•
mount and the direction of the fan cable.
Ensure that the assembly is locked into the keyholes
•
Fan mount tab
6000 Series Oscilloscopes Service Guide
Keyholes
in deck