Figure 29 Removing The Backlight Inverter Shield - Agilent Technologies 6000 Series Service Manual

6000 Series Oscilloscopes Service Guide
8 If the e-field shield requires replacement, use a screwdriver
to pry the shield off the studs.
Figure 29 Removing the backlight inverter shield
9 To reinstall the backlight inverter board:
a Align the shield over the studs and push it all the way
down on the studs.
b Reconnect the LCD cables looping them around each other
and through the cable guides as shown in
c Reconnect the supply cable.
d Align the holes in the inverter board with the posts on the
display mount and push down until the latches snap over
the board (refer to
e Route the cables through the cable guides as shown.
Replacing 6000A Assemblies
Studs
Figure 28).
5
Figure 28.
109