Figure 38 Removing The Fan - Agilent Technologies 5000 Series Service Manual

Fan mount tab
Fan mount
Fan
Fan cable
5000 Series Oscilloscopes Service Guide
3 Slide the fan mount to the side to remove the 4 retainer
hooks from their keyholes and lift out.
It may help to push on each of the hooks to keep from tearing
them.
4 Peel the rubber fan mount off the corners of the fan.
Figure 38 Removing the fan
5 Reverse this procedure to replace the fan assembly.
• When re-installing, note the position of the tab on the fan
mount and the direction of the fan cable.
• Ensure that the assembly is locked into the keyholes, fan
tab is located at top and fan cables egress as shown.
Replacing Assemblies
Keyholes
in deck
5
107