Modes Of Operation; Leak Test Mode; Available Ranges; Features - Teledyne Everywhereyoulook GT-FIRE User Manual

GT-FIRE
PORTABLE GAS DETECTOR

4. Modes of Operation

4.1. Leak Test Mode

Note: The monitor pump must be switched ON to perform correct measurement in Leak
Test mode.
This mode is used to investigate odour or leak complaints and pinpoint leaks.

4.1.1. Available Ranges

• 0 – 2000 ppm Methane
• 0 – 100% LEL Methane
• 0 – 1000 ppm Carbon Monoxide (CO) if fitted

4.1.2. Features

Leak Test mode features:
• Audible / Visual PPM Ticker (Geiger) alarm
• Ticker threshold adjustment
• Audible / Visual Gas Alarms
• Pump ON / OFF (will stop automatically if flow fault is detected)
• Max Display
• Methane autoranging (ppm and LEL)
• Display Invert
• Automatic datalogging
• Backlight
• Flashlight

4.1.3. Display

Note: Continuous display of both Methane and CO is a configurable option, as
shown in Figure 18: Methane +
18
Figure 17: Methane Only Display
CO.
67816
Revision D