Table of Contents
Advertisement
Installing U10 USB Network Interface Adaptor
To use this product, turn on the power of the PC and install necessary drivers/software for this product (BE-
FORE connecting it to any USB port ), following the ***QUICK START*** enclosed with this product.
When using multiple U10 USB Network Interface adaptors, confirm in advance, which U10 USB
Network Interface adaptor connects to which VRF Network (Attach labels to the U10 USB Network
Interface adaptors If possible). These information will become necessary during the setup procedure
®
of BACnet
Gateway (You will be required to specify which U10 USB Network Interface adaptor corre-
sponds to which VRF network).
1
LON1
LON2
LON(
LON4
Keeping a record of a table such as shown below is recommended.
LON No.
LON1
LON2
LON(
LON4
Note. "LONx" is used to identify U10 USB Network Interface adaptor. LON numbers are given in the or-
der they are inserted to a PC for the first time and basically, never changes, even if you change USB slot
afterwards.
Connect the U10 USB Network Interface adaptor to the personal computer USB port.
When there are multiple U10 USB Network Interface adaptors, connect each U10 USB Network Inter-
face adaptor in the order of its LON number.
Copyright© 2010, 2011 Fujitsu General Limited. All rights reserved.
VRF0
VRF1
VRF2
2
3
4
Adaptor No.
Adaptor 1
Adaptor 2
Adaptor (
Adaptor 4
15
VRF(
VRF System No.
VRF 0
VRF 1
VRF 2
VRF (
Advertisement
Table of Contents
