Cover Of The X-Ray Unit; Cover Of The Horizontal Carriage - Siemens SIREMOBIL Iso-C 3D Installation Instructions Manual

Actions up to serial number 1408
•
Proceed as follows after the SIREMOBIL Iso-C has been moved to the respective room
and the foot brake has been enabled.

Cover of the X-ray unit

•
Remove the cover.
•
Remove the protective conductor.

Cover of the horizontal carriage

If LITHOSTAR MODULARIS option is installed:
NOTE
•
Remove the cover (= 6 Allen screws) and pull connector M3.X1.
•
Unscrew the protective conductor.
•
Remove the brake assembly.
•
The assembly previously removed has to be integrated into the new cover.
Fig. 1 Cover plate
•
Deinstall the cover plate. It will later be replaced by a new one (Fig. 1).
Siemens AG
Medical Solutions
After the installation of the SIREMOBIL Iso-C 3D upgrade, the
external part of the docking plate must be reinstalled. Perform the
installation and setting of the switches as described in the
LITHOSTAR MODULARIS Service Instructions.
SPR2-230.814.01
Rev. 05
Page 1 of 14
08.04 CS PS 24
2 - 1
2
2
2
SIREMOBIL Iso-C 3D